Anycubic Mega X Marlin 1.1.9

thingiverse

This setup applies specifically to the Anycubic Mega X model printer. In this configuration, I have adjusted the print settings for 2208s in both the X and Y axes only. The maximum travel acceleration has been increased to 1200, which was initially set too low at 400. This value is lower than what my Chiron printer uses despite its larger size. If needed, you can change these values without modifying the Marlin software itself by making adjustments via M201/M204 commands. To enhance print performance, I've also raised the Print Acceleration to 750, matching the settings used on my reliable braced Chiron with no issues encountered. The Mesh Bed Leveling feature has been successfully tested and is now functioning properly. Additionally, the Part Cooling Fan has been upgraded from 8.6V to a more powerful 12V setting.