Anycubic Mega S Trigorilla to MKS Tinybee adaptor

thingiverse

Ongoing project to integrate MKS Tinybee into my Anycubic Mega S. The mainboard mount is complete, now fiddling with the firmware. Note that Tinybee has only 4 endstops, so I forgo the filament runout sensor, keeping X, Y, and dual Z. I have the firmware running but still tweaking it to my liking. I am not sure if it will work for SKR boards or similar boards with same board size and holes due to the connector positions might be different. I wanted to see if 32 bit mainboard would improve performance and saw this MKS Tinybee + mini12864v3 going for less than USD30 at time of my purchase. I liked the design by Steho_83 but wanted the Tinybee ports to face the holes to make it easier to have the cables go out of the enclosure. I used the USB C that came with the Tinybee and it can squeeze between the standoffs. I kept the mounting holes for the original 40mm fan as close as possible to the original as I know that there are many fan solutions that utilize those holes. There is now more depth to add a thicker fan. If you are interested, check out my design for mini12864v3 housing https://www.thingiverse.com/thing:5401579 or dual 5010 fans mount https://www.thingiverse.com/thing:5196689 Things that you'll need: - 8pcs M3x5 screws (it is possible to use back the screws taken out from the SD card reader and Trigorilla mainboard) - 4pcs M3 washers - 6pcs M3 brass inserts Affliate links: MKS Tinybee and mini12864v3 https://s.click.aliexpress.com/e/_Anj8yD M3 screws https://s.click.aliexpress.com/e/_AX4tAp M3 washers https://s.click.aliexpress.com/e/_A952El M3 brass inserts https://s.click.aliexpress.com/e/_AXQ1Vf (cheaper but not easy to use) https://s.click.aliexpress.com/e/_AWSAON (better holding torque)