Anycubic Mega-S Part Fan Duct Two-Sided (Remix)

thingiverse

I made several adjustments to the original design to make it fit better on the Mega-S and reduce required support: 1. I shifted the rear blower about 5mm away from the nozzle, which was previously off-center, so hopefully PLA will print without issue again, as I'm struggling with printing a ring-style one in ABS. 2. I added more substantial screw holes for improved stability. 3. I modified certain walls to accommodate my original Mega-S part cooling fan. 4. By incorporating slopes, I significantly reduced the amount of support needed. Here's my revised half-circle version for the Mega-S: https://www.thingiverse.com/thing:3733579 And here's my updated half-circle hotend cover version for the Mega-S: https://www.thingiverse.com/thing:3736680 EDIT: I added an updated version with lower fan ducts