Anycubic Mega S - Mega X Spool Support

thingiverse

Simple and lightweight spool holder support designed specifically for Stock Anycubic Mega S and Mega X 3D printers. This adaptable design accommodates a wide range of spool sizes, from 35mm to 81mm in width. To install, simply snap the stock support into place. Please note that when using an 81mm spool, it's essential to position the left and right spools correctly on each side of the stock support to ensure a secure fit. Required components include: Two 608zz bearings with dimensions 22x8x7mm. When printing this support, use supports with a z-offset of 0.2 or 0.25 mm from the model surface. If your printer is accurately calibrated in terms of dimensions, scaling may not be necessary. The estimated total cost for printing this support is approximately €0.50, excluding the cost of bearings. In CURA, rotate the prints by 90 degrees on the Y-axis to minimize the use of supports.