ANYCUBIC MEGA MODS

thingiverse

Tried printing adapters without success, as they didn't fit correctly. For example, cables were not long enough in their natural state. My cable kept slipping out from behind the extruder and the outer shielding was getting sawed by the belt. Yes, a cable tie would have helped, but high object prints caused the bowden tube and cable to jam under the top frame. So I created custom-sized cable links since others were too large for the job and designed matching snap-fit clips. No threading through multi-plugs was needed with this design. 23 Links were required on my setup. I had to mark and drill an extra hole in the right-hand bracket for a self-tapping screw and fit a small washer on the other side to prevent cable squashing. On January 18, 2020, updated the R/H bracket for a better fit. On January 18, 2020, added other parts to the kit.