Anycubic linear power panel

thingiverse

This is a custom power connection panel designed specifically for the Anycubic Linear Plus. The original power cables were attached directly to the controller board, making it rather inconvenient. To address this issue, I decided to convert the entire setup to use XT60 connectors, which are more familiar to me due to their widespread use in drones. To secure the new XT60 connectors in place, you'll need three M3 screws and corresponding nuts. These components will provide a sturdy hold for the connectors. When attaching the panel to the printer itself, I had to rely on four additional M3 screw and nut sets, as the original kit's screws were depleted during assembly. However, please note that the M3 screw back plates are only necessary if you choose to pursue this DIY modification. If you're interested in exploring alternative power supply configurations, you may want to consider my other design, which features two XT60 connectors connected directly to the power source.