Anycubic Kossel Plus Probe Mount

thingiverse

Update: I've discovered that the connecting rods are slightly off-center, causing a tilt error on the effector. This discrepancy amplifies the measurement result due to the sensor's offset position. That's why I don't recommend using this probe on a Kossel. This touchless probe sensor mount takes up no printing space. The probe simply hangs between the rod ends, with nothing touching at all within a 116mm radius of the Kossel Plus. The Mount is designed for a 12mm diameter sensor. To calibrate, I touched the Ground with Nozzle to paper and tightened the sensor until the signal LED lit up. No Z offset is required anymore. The Y Offset on my Printer is just -36mm with standard effector. I chose to secure the sensor in place using superglue, but there's no need for it. My sensor requires a minor soldered current boost. If you know of a Probe that doesn't need extra electronics, please share your findings in the comments below.