Anycubic Kossel Plus Marlin 2.0.7.2 btt skr 1.4 turbo + TMC2209 UART.

thingiverse

WARNING: After flashing, perform an EEPROM reset using commands (M502 - Reset settings to factory defaults, M500 - Save results) Flashing the Anycubic Kossel Plus printer board with SKR 1.4 Turbo and TMC2209 UART drivers. The flash is set up for this specific board and is ready for assembly. You may need to properly install endstops and motors. Use Visual Studio Code + PlatformIO for assembly. Release version V1.1 (10.11.2020) Assembled on a clean release of Marlin-2.0.7.2 and a clean config. Changes in the release: - Improved performance. - Correctly set extruder steps. We recommend updating to the new version. Release version V1.0 (07.07.2020) Assembled on a clean Marlin 2.0.5.3 and Clean Config. Changes in the release: - Added the ability to measure height "SET DELTA HEIGHT" in the menu. (Change in the root of the flash, not in the configuration) - Set extruder motor steps for accurate filament dosing. - All motors are inverted (This is necessary so as not to flip pins on the motors) - Pin HE1 redefined. Now connect the cooler to the HE1 socket observing polarity. - Pid calibrated for Hotend and Bed. Standard configuration settings. PS: Huge thanks to the community https://vk.com/3ddelta, as well as people from Telegram. Without them, I would not have been able to assemble this build. If you make any changes to this configuration and upload it to the network, please add to the list. https://cdn.thingiverse.com/assets/da/e2/85/7b/2a/.PNG