Anycubic Kossel Plus - Bed support + insulation + glass with clamp

thingiverse

Starting from the base Yakandu I've added some small clamps to securely hold the entire assembly in place without any movement. By eliminating the use of large clips on the glass, I've eliminated problems when leveling or printing parts. This support is designed specifically for an Anycubic Kossel Plus (240mm) printer, where you're using: * Cork as insulation * The original hot bed * A 4mm crystal The total height of this setup is 10mm. For assembly, you'll need: * Two original M4 screws * One set of M3 nut screws You have two options for clips: the V3 model works best with crystals that are slightly smaller than the bed, while the V2 model has less margin and is ideal for glass flush with the bed. Remember to print these parts in ABS!