Anycubic Kossel Plotter Conversion

thingiverse

Reset Z offset in your slicer for the fine liner. Use the STL converter found at https://www.thingiverse.com/thing:66115. This will typically produce an STL that is thicker than one layer. One layer equals one pass, so either stop the print when it begins doing the second pass or adjust the Z scaling to make your slicer only produce one layer. I run prints at 50mm/s. I keep the Extruder/Hotend setup connected to the printer but disconnected from the push-rods. Make sure temperature control is disabled if your machine is set up correctly, it will not extrude cold. So you can leave them connected. REQUIRES: 3 tension springs 3 lengths of string 1x Stabilo point 88 fineliner. It may work on other pens but has not been tested.