Anycubic Kossel Linear Plus SKR 1.3 Marlin 2.0.x - OBSOLETE, SEE DESCRIPTION.

thingiverse

THE FIRMWARE HAS BEEN OVERHAULED WITH THE MOST RECENT VERSION OF MARLIN, AND IS NOW BASED ON THE PARANOiD CONFIG THAT THE POPULAR SKR 1.4 FIRMWARE IS ASSEMBLED ON. FIND IT HERE: https://www.thingiverse.com/thing:4081644/ WARNING: Download and install AT YOUR OWN Risk! Make sure the following applies to your printer before you continue: ANYCUBIC KOSSEL LINEAR PLUS BIGTREETECH SKR 1.3 BOARD TMC 2208 Standalone OR - TMC 2208 UART From BIGTREETECH You will have to modify the Configuration.h, and configuration_adv.h files for anything that doesn't apply to the above, including the non KLP AC Deltas. This is a Marlin 2.0.x for SKR 1.3, specifically for a UART config, and a Stand-alone Config. It has Linear Advance enabled, so either disable it through the screen, through Atom, or calibrate it using the following guide: https://www.youtube.com/watch?v=c5jjwBqARpo If you have the BIGTREE SKR 1.3 with Standalone TMC 2208s, use the Standalone software zip. If you have the SKR 1.3 with UART BIGTREE TMC 2208s, use the UART software zip. Here's a video below that will help you get set up with the latter, and other bigtree TMC drivers. If you use other drivers (I.e. 2209, or 2130), please post a remix to keep the software availability to a maximum. https://youtu.be/k3Uc1F5jgVQ?list=PLDM0yCsY_xFm6X8aQhTK4dXkAD7BaAPV4&t=851 Chris Riley's guide on the SKR config is great: https://www.youtube.com/watch?v=duNHOPlh2Pg Big thank you to everyone who contributed thus far - let's keep this going so that Anycubic either gets their act up with the Trigorilla, or starts offering their printers with an SKR board straight from the factory, because those TG boards are embarrassing. Make sure you're ready to brick your board, and have to warranty it - because I had to with my first one. Thus far, it's working fantastically.