Anycubic Kossel Linear Plus Light weight Effector upgrade E3D V6 (Volcano too) and 5015 blower

thingiverse

I want you can make it complete with very lightweight rods (9g each) https://www.thingiverse.com/thing:4396638 After assembly I realized the screws M3x20 for horseshoe clamp are longer so they go out a little from the wall outside. I adjust clamp so they are hidden in the hole now as it should be. Added blower holder with bigger hole 4 mm for our friends from US, they have a problem to buy some metric screws. Also added offset holder for magnetic holder for original calibration switch. And use the most powerful fan 30x30x10mm or 30x30x15mm better. I am using Sunon 30x30x15 mm type: MC30151V1-000U-A99. The heatsink needs to be cooled well to prevent heat creep. Especially PLA is sensitive. Also titanium heatbreak is a good choice, I recommend it highly. Added air nozzles for Volcano V6 hotend. I changed the horseshoe so screws M3 x 20 mm are long enough to reach nuts in the pocket. I realize this problem after print testing model. This is second version of the effector for Anycubic Kossel Linear Plus, which has low mass, has more efficient cooling of the heatsink (no risk of heat creep). Due to sealed design, fan blows directly to the ribs of heatsink and air is forced to flow through ribs, because there is no space around heatsink, where air could bypass heatsink as it is in original design of effector. It has much more powerful radial blower 5015 for cooling print. Air stream is split to 2 channels and air blows from 2 big jet nozzles to the printing area, but not to the printing nozzle. With this effector you can print faster but more safe without heat-creep, temperature run-out and any other unwanted issues. Effector is fully compatible with original one, you can use original magnetic calibrating probe switch. There are holes for putting the holder on. Please use powerful fan 30x30x10 for cooling hotend to prevent heat creep and clog especially PLA...