Anycubic Kossel Linear Plus E3D V6 Effector

cults3d

I made the connecting rod mounting points longer so I don't have to use the copper spacers anymore. They are 52mm wide without spacers. I added a small round brim under each mounting point to help minimize warping. Trim away post print. I added a nut pocket so I can use a 3mm X 20mm bolt with a nut and with the rod end installed, the bolt will just reach the nut. I have noticed with repeated assembly and disassembly that the mounting hole for the E3D will start to get a little loose, so I added 3 screw holes pointing in towards the center, to help lock down the E3D. The top collar does a pretty good job of holding it secure, but it is better with the 3 screws. Just don't over tighten them, snug is enough. The top collar - will take (2) 3mm x 15-20mm screws and nuts. 20's will work but 15's look a little better. I have 2 square holes on each side. You can either pass wires through the holes, or use the holes as anchor points for wire ties, or use my little wire clips. I made a holder for my bore scope, a tiny camera inside a 10mm diameter housing. I made a stand for my effector with the extended rod bearing anchor points. Makes it a little easier to work on. Also doubles as a display stand for your spares. I am still working on the carriages. I have them printed but not installed yet. Same thing, no copper spacers. The rod end mounting points are 52mm wide. These were just a very minor remix. I placed the nut pockets on top because, well, gravity sucks. I added a tiny brim and support for accuracy and non warping. Trim away post print. I re-mixed (again) some carriages that really are belt tensioners too. https://www.thingiverse.com/thing:2653647 I printed these in ABS with 50% infill. effector 2640121 carriages 2653647 fan shroud 2846998 UBL adapter 2847002