Anycubic Kossel Linear Plus E3d V6 Effector

thingiverse

This is a straightforward clone of the standard metal effector found on the Anycubic Kossel Linear Plus. All dimensions and sizes are identical, allowing for seamless integration. It's specifically designed to accommodate an E3D V6 hot end, and the unit shown in the image is a replica. Users can then select from various fan duct options; any fan duct that clips onto the hotend fins should be compatible, as seen in the provided picture. The design is available on Thingiverse at https://www.thingiverse.com/thing:1373201. This clone performs admirably and fits snugly without requiring screws. Its implementation comes with a trade-off, reducing the available build height by approximately 30mm. However, this reduction was deemed worthwhile to enable enhanced part cooling. The clamps utilize M3 screws, four in total, and users are advised to print two of these units. The arms of the effector attach securely using the same mounting screws. It's essential to note that when employing the same fan duct, insulate the hot end from the heat block to prevent overheating.