ANYCUBIC Kossel Delta Filament Cooler (Fan Duct) REMIX

thingiverse

I designed my own remix of this duct because I preferred the ventilation system, which was superior to all others I had tested. However, every print I made quickly began to melt and sag, posing a significant risk of snagging the print and breaking it free due to the extremely sharp tips on the hanging end. This remix eliminates the two outermost holes, making the entire duct slightly shorter and rounding off its edges while slimming down its overall shape to match the sides of the effector plate. The inside diameter was increased by 1mm to position the duct farther away from the hotend. I also added two additional screw holes on the interior to make use of all four screws, minimizing the likelihood of the vent sagging over time. Getting the screws in requires some patience, but they can be accessed through one of the vent holes directly above them and fit very tightly against the effector plate.