Anycubic Kobra Plus/Max/Vyper filament senor 45 degree mount

thingiverse

I change some design from this model (https://www.thingiverse.com/thing:5203968) to lower the tightness of filament sensor cable and move the sensor more toward the printer thus remaining all screw in place ****This parts is only suitable for those who mount their filament mount on top of the 3D printer**** Parts needed: Anycubic Kobra Plus/Max/Vyper filament senor 45 degree mount X 1 M3 X 12 mm screw X 1 M3 nut X 1 Installation Step: 1) Remove the filament sensor and the bottom plate 2) Use the original screw to tighten the parts to the 3D printer 3) Put the M3 nut inside the parts through the side holes 4) Insert the filament sensor into the 45 degree hole till the end 5) Use the M3 X 12 mm screw to tighten the filament sensor in place 6) Have a nice printing experience ****I don't have a M3 X 12 mm screw, so I use a M3 X 16mm screw which is not fit as seen in the picture above****