Anycubic Kobra Neo Z-Axis Stepper Mount

thingiverse

This is a remix from a purchased part, not a thingiverse part. When you buy a dual z axis kit, a lot of times they are Ender-specific and include t-nuts that you cant use because the anycubic version is different. Just print this out and use it to mount your stepper! Requires at least 2 M3 screws (ideally 4 for stability) and 4 t-nuts for the side-mount screws Will most likely require you to remove the top bar, remove the pom wheels and slide the mount along the z-axis extrusions since they will be stiff and can't easily bend. They will NOT snap into place. Finally, a tip about alignment: bring the X-Axis gantry / nozzle down as close to the bed as possible before you tighten up the M3 screws on the stepper motor. This will prevent the travel components from binding.