Anycubic Kobra Left Side Slide In Ball Mount

thingiverse

This allows the system to be mounted to the left side of the frame on the Anycubic Kobra. **It slides in, it does not clip in so don't try to force it in. Take the rubber piece off the end and slide it in.** I made it the height it is so that the first piece you clip onto it would be in-line with the bed, making it easier for you you plan out your pieces and for it to not interact with the bed ie, crash into it. For best results, print it ball side down with tree supports and a brim at 0.2 resolution, 4 wall thickness and 20% fill. I left a 0.5mm allowance for movement so you could probably print at 0.3 res but the ball may not move smoothly and I cannot guarantee it will fit properly in the channel. Also, for this piece and the system in general, I highly suggest using PETG at a minimum because PLA will eventually warp due to it being so close to the bed or in an enclosure. I found that if you are having issues with the clips slipping, printing the tightest clip at 97% scale takes care of that issue and the system still works.