Anycubic Kobra Go E3D V6 Adapter

thingiverse

I snapped the factory Kobra nozzle in the factory heater block so I decided I would just upgrade it with an E3D V6 I had on an old no longer functional printer, of course this demanded a mounting solution which I was unable to find pre-existing. This mount is designed to work with the stock factory shroud, though it does require a shorter M3 bolt for the mount, longer M3 bolts for the shroud, and a set of M3 bolts and nuts to bolt the bracket to the mount that holds the V6 in place.Since the diameter of the E3D V6 is larger then the stock hotend spacers are used to extend the shroud out 6mm, this is why longer M3 bolts are needed for the shroud mount.The mount is designed so that the nozzle tip is roughly at the same position as factory, of course you will need to adjust your Z offsets to make it perfect (mine was within 0.4mm of the stock nozzle on my Z offset).