Anycubic Kobra Filament Trash Tub - Updated

thingiverse

Remixed the very useful Anycubic Kobra Filament Trash Tub, because it's too tall. If placed at the position showed in the pictures, it has no use: the nozzle stops **outside** the tray, so when leaking filament after a print or during pre-heat, it drips **on** the machine. If put **against the gantry leg**, which is the correct position, it bumps into the cable connector when the bed is extracted. So I simply cut half an inch from the upper part to make space for the connector to pass over the tray. Now you can keep the tray against the gantry leg.