Anycubic Kobra - Dial Indicator Mount

thingiverse

Dial indicator mount for Anycubic Kobra. You will need to remove your extruder head shroud to install. You will also need to replace the factory plastic spacers under your bed with silicone spacers. This will allow for the needed adjustments. Uses the existing threaded holes on the side of the steel housing. You will need to get longer M3 bolts to replace the factory bolts though. Only other fastener you will need is a 1/4-20 x 0.75" bolt and nut. This mount is meant to stay in place after leveling as it does not protrude below the bed sensor nor interfere with any other operations. Simply install indicator, remove the build plate for access to bed screws, level your bed, replace build plate to verify, then remove the indicator and begin printing. Your indicator may or may not fit this mount. The distance between the bolt tabs is approximately 0.25". The hole for the plunger is a little bigger than the 0.375 dia of the indicator. I will be updating to get a more snug fit for the nut, but this configuration works for now. Feel free to contact me with any modifications or questions.