Anycubic Kobra Dampening Feet

prusaprinters

<p>Modified the original design to accommodate the Anycubic Kobra.</p><p><strong>There are two files, one you print three of, the other you print one of. </strong>The file you print one of is for the back left corner where there are a few screws and plates that prevent the channels from being used and needs a bit of clearance. I just stuck a little double sided tape on it where the channel bits would usually be to make sure it stays in place.</p><p>The original design is great, I didn't change anything except for the filament for the Kobra because it lifts the printer about 29mm while also providing absorption for vibrations that can cause ghosting in prints.</p><p>I printed them out of PLA at a resolution of .3 with 40% fill as they do have to be strong, I wouldn't reduce the fill, you don't want one of these to fail.</p><p>Print them on their side with tree supports for the best result with the least amount of supports.</p>