Anycubic Kobra bed cable chain

prusaprinters

Printing-No supports are required. Use a brim on poor bed adhesion surfaces.-You will need to angle the chain 45 degrees to fit.-Keep in mind that this is a print-in-place design, so your clearances need to be tuned well. Assembly-Organise the cables coming out of the base, and unscrew the closest bolt to the motor like so: -Bolt the chain on like this: -Then insert the cable and clip the retainer clips in the holes on the chain to keep the cable in place. This might be a little hard as it is quite small, but try moving the bed around for a better angle