Anycubic I3 with SKR1.3 32bit + Marlin 2.0

thingiverse

Adapter for Bigtreetech SKR 1.3 to Anycubic I3 Mega Firmware is designed for TMC2208 2.0 or higher with UART (without filament sensor, activated through firmware) with BLTouch. You need: * Motherboard SKR 1.3 * 5 TMC2208 V2 * Display: KSR TFT35 and/or 12864 RepRapDiscount Full Graphic Smart Controller * USB-B extension * SD card extension * Plugs and sockets * Antlabs BL Touch V3 * M3 bolts and nuts * 3-wire strand * Capacitor 500 uF at 5V (when using 2 displays simultaneously) Disadvantages: * The case fan is not controllable. * To place the display in the housing, a screw guide must be broken away from the Any and a corner filed off the display. * It gets louder again. Advantages: * The firmware and display are modifiable. * TMC2208 can easily operate in UART mode. * 32-bit, steps are calculated faster. * Further tests are still pending. Who wants to edit Marlin2.0 itself? Instructions in the Word file. KSR TFT35 firmware in English: https://www.dropbox.com/sh/p2sasy5zqlv8p8d/AACfHpKsdgP0HpKn0R2wpLNpa?dl=0&fbclid=IwAR0P50o_vpGmIDOrSjcSxwBKwXdFp0VWY8x1WebyNDrfhNkckPojH20wq0c !!! Change baud rate to 115200 baud in config.txt !!! The board also supports 2.8-inch and 3.5-inch color touchscreens and 2004 LCD and 12864 LCD. It soon follows: Modified display firmware. The installation of the faster motherboard is worthwhile only if the Any has been mechanically improved. https://www.thingiverse.com/thing:3589645 Problems: Checksum error while printing from SD card at TFT32