Anycubic I3 Mega Spulenhalter

thingiverse

Stable Filament Spool Holder for the Anycubic I3 Mega. I used the very stable metal holder from Anycubic and built a 50mm axle around it. The narrow disk as left boundary, the middle and large one as right boundary of the spool, where two can be counter-rotated against each other. The tip is only an optical outer boundary, either pointed or rounded. An adapter for spools with an inner diameter of 70 mm instead of 50 mm. Now the spools run smoothly without jerks and do not wobble on the axle. The extruder is thus protected. I reworked the central axle because it was too tight inside for the metal plate (15.2.2020). The internal thread of the three large screws can be determined yourself, depending on whether they should run more tightly or loosely. At my place, 51.3 mm works well.