Anycubic i3 Mega S Y-carriage Belt Tensioner

cults3d

Anycubic i3 Mega S Y-Carriage Belt Tensioner UPDATE: Added a Carriage_mk2 file which features a slightly sturdier back. I noticed after a year of use and perhaps slight over-tensioning on my part, the screw that pulls the carriage back has started eating into the carriage and is now protruding a little on the back-side. Nothing has failed yet so far but I decided to beef up the carriage a little. Failing to find any good stream-lined design out there, I went ahead and designed my own Y-carriage belt tensioner. The only one available had a nut and bolt that protruded past the LCD screen which I didn't think much of. Also it was ugly. DESIGN SPECIFICATIONS: Streamlined design with zero interference. Reinforced ribs for rigidity. Print without supports. Ease of installation with the use of existing holes without the need for drilling into the machine. HARDWARE NEEDED: 3 x M3x12mm screws (doesn't matter if it's socket head or buttons head) 1 x M5x20mm screw (has to be button head - for clearance) 1 x M5 nut 1 x M5 washer 1 x M2x25mm screw (has to be button head - for clearance) 1 x M2 brass hot-melt insert nut. (or you can use a M2 nut if you don't have a hot-melt insert.Use the knob_hexnut.stl file for this) 3 x M2 washers INSTALLATION: Press fit the M5 hex nut into the underside of the carriage. Make sure to press it until it sits flush. M2 screw with one M2 washer goes into the small hole in the carriage. Screw this in but be aware that it is a tight fit so that it holds in place. The reason is so that when you screw the knob over it during usage, this screw will not spin. Loop the belt over the pulley and slide the pulley into the carriage. Screw the M5 button-head screw into the carriage, securing the pulley into place. Do not overtighten or the pulley will catch! Test to make sure pulley still spins freely. Install frame by removing 2 of the inside screws of the linear rod mounts, and one of the screw that holds the power supply. Screw in the M3 screws into the respective places. Make sure the frame is flush to the machine. Screw it tight. Around quarter turn after hand-tight should do it. Hot-melt the insert into the knob. Make sure that you thread a screw in and check that it runs smoothly after you've hot-melted the insert. Wouldn't hurt to spray whatever lube you have in the threads (i.e PTFE, WD-40 etc). Clean off any plastic residue from hot melting. If you have a tap, now would be a good time to dust off the cobwebs on that and use it here. (TIP: I usually put a screw into the insert way and hot melt it with the screw in place so that any bulging plastic from hot-melting does not go into the insert cavity. Just be sure to wait until it is cold before removing the screw.) Assemble everything together. Slide carriage into carriage slot of the frame. Place the 2 M2 washers stacked on top of each other on the other-side of the frame (this is so that the plastic knob doesn't rub on the frame plastic knob cavity. Screw your knob on and tension the belt. NOTE: The design is dimensionally accurate. If you are not getting accurate parts, then your printer needs to be tuned and calibrated to print accurate parts. The design has been printed and checked for dimensional accuracy.