Anycubic i3 Mega s Cover Power Supply

thingiverse

A power supply housing for the Anycubic i3 Mega S.The case is inspired by:https://www.thingiverse.com/thing:3306465https://www.thingiverse.com/thing:4282600Unfortunately, the existing cases did not fit due to fan and case dimensions. That's why I created my own case!My basic idea for the design was as follows:the fan from the power supply should suck in the air at this position so that the 120x120 fan above the mainboard cannot suck in warm air from the power supply. Instead, the air should run through the entire power supply unit and be expelled to the rear (towards the Y motor). Basically, the air should rather come from the front (Y-motor deflection) in combination with the large mainboard fan to push the air backwards and sideways out of the case.i didn't want to spend 20€ on a fan and couldn't find a 10mm high fan. Therefore a 15mm fan had to be recessed.2x cable holders for tidiness and airflowlabeling remains the sameNotes:For 92mm fans with an 83x83mm hole patternFan used: Thermalright TL-9015BFan looks out about 2-3mm at the bottomSupport material for the 220V/110V window is already "designed in" and can be easily removed with a cutterI have created a reduced test part (...TESTPART) for a test printDesign attached as .step fileStay healthy and have fun with the coverIf you like this or one of my other parts, please leave a small donation at my PayPal address:sascha.kolodzie@gmail.com