Anycubic I3 Mega/Mega S X dragchain mounts

thingiverse

This is a remix of Michelix's Schleppkette für Anycubic I3 Mega, using the single sided pivot links from Thingiverse made by ModelStation. The links used in Michelix's original model pivot in both directions, and I wanted my chain to roll only to the inside, while remaining straight and flat on the outside. Also, I'm using ModelStation's link on my Anet A8, so I'd like to keep my two I3 clones somewhat uniform. Be advised that the 14 pin connector at either end of the hotend electrical cable will NOT fit through these links and one end will have to be decoupled before fishing the wires through the completed chain assembly. Pay close attention, label if necessary, the orientation of the wires in the connector before disassembling it, and reassemble it using the original configuration. ModelStation's links can be found here: https://cdn.thingiverse.com/assets/1c/7c/fd/70/7a/CableChainx4.stl The full link to ModelStations design is here: https://www.thingiverse.com/thing:11978 I used only 22 links on my chain.