Anycubic I3 Mega LED Light with Switch

thingiverse

LED Light for Anycubic I3 Mega. The Holder for the Switch is secured by two Screws from the Hot-End Fan, which require two M3x20 screws. The old ones are too short, so replacements are necessary. There might be some slight inaccuracy with the holes drilled into the Holder. The Holder for the light is attached using the lower two Screws from the Hot-End Fan, also requiring M3x20 screws. Make sure to tighten them securely. The LED Light is connected directly to the Hot-End Fan via a simple circuit that incorporates the switch. Components Needed: - An LED ring rated at 12 volts for the Holder, available on Ebay: https://bit.ly/2DcqoUi - A two-pin Switch from Ebay: https://bit.ly/2OCd2li - Four M3x20 screws