Anycubic i3 Mega lateral cable support

thingiverse

Human: Lateral Support for Left Motor Wires for AnyCubic Mega I3 s Assembly: Remove the screws from the extruder end-of-stroke sensor, then place the support on the outer part, which is the most challenging section. Next, tighten the screws and hold the sensor in place using its metal bracket (just be patient and screw them together slightly at a time before tightening too tightly). Finally, route both wires over the base and secure with a clamp. Montaggio: Disassemble the extruder end-of-stroke sensor by removing its screws. Then, position the support on the outer part, which is the most difficult area to access. Secure the support in place using screws while holding the sensor steady with its metal bracket (it's essential to work carefully and tighten the screws one at a time before applying too much pressure). Once you've secured the support, guide both wires over the base and apply a clamp to keep them in place.