Anycubic I3 Mega Kabelkette Hotend zum Extruder

thingiverse

After a short time (2 months) I had a wire break in the hot end cable. Therefore, now a cable chain to prevent the cables from being bent too much. The basis of the cable chain is the construction "Std Range Cable Chain Link" by ayourk@gmail.com from Tinkercad. From this, I printed 25 elements and a holder for the hotend and another holder next to the extruder. In addition, an additional holder at the hotend so that the teflon hose can be led backwards a bit, so it does not bend when larger prints at the upper edge of the printer. I shortened two elements of the chain by cutting off part of them to enable better mobility of the chain in both directions; immediately at the hot end anchor and the last 2 elements at the extruder holder. For the extruder holder I drilled 2 holes (3.5 mm) and then expanded to a 4 mm thread to secure with two 4 mm screws. Now the hotend cable is not bent so extremely when in maximum left or maximum right position.