Anycubic i3 Mega Filament Funnel for Sensor

thingiverse

Finally introduce the filament without fumbling.!!! A funnel and tube for guiding the filament into the Anycubic I3 Mega's filament sensor. Assuming you attach the filament sensor directly below the stepping motor, just like I do, without that wobbly magnet. Instructions: - Remove the cover from the sensor. (It clips on, so no need to open any screws.) - Use pliers to remove the two short tubes on the sensor. - Attach the funnel from underneath using a 2-component adhesive. - Don't glue the tube on top; that will give you better access to the screw. - Tighten it, but not all the way, and don't forget the spacer between the sensor and the frame. - Rotate the sensor 90 degrees, attach the tube, rotate it back 90 degrees, and secure it tightly with a short hex wrench. - Put the cover back on, and you're done.