Anycubic i3 MEGA - Camera mount

thingiverse

A single print camera mount that fits snugly just below the build plate. I recommend increasing the infill percentage for added sturdiness, aiming for 50% or higher for optimal results. No supports are required; the model should be pre-positioned in the slicer before printing. As a Cura user, I've only tested this on that platform, and I place the model at a right angle to the fan to minimize the risk of it being blown over. After three successful prints, I'm confident in this design's reliability. UPDATE: I have two i3 Megas, one from December 17 and an older one from August 17. I discovered that on my older printer, the plate beneath the build plate where the camera mount attaches is slightly thinner. Specifically, it has a clip thickness of 2.85mm. To address this, I plan to create another version of the mount that accommodates the varied base thicknesses found in different i3 Megas.