Anycubic i3 Mega cable guide

thingiverse

When I first started printing with my Anycubic i3 Mega, I noticed that the extruder cable is subjected to sharp bends due to its direct attachment to the extruder. This led me to worry about potential cable fatigue after a few weeks of use. To alleviate this issue, I designed a small cable guide that helps reduce the strain on the extruder cable and prevents it from being concentrated at a single point. With this new part in place, the cable now runs smoothly behind the upper bar as the extruder moves to higher Z-values. To secure the new cable guide, I attached it to the extruder casing using a cable strap and also fixed the cable's exit point at the top end of the guide with another cable strap.