Anycubic I3 Mega Bondtech + E3DV6 + BLtouch

thingiverse

Don't get hung up on Wire Management XD!! I'm having a hard time finding a good, direct drive head for the Anycubic. This one is straightforward - ready to go for BLtouch, Tiny NEMA 17 (Pancake), Bondtech_BMG directdrive with E3DV6 hotend. Easy access to PCB wires and a support for rear wires too! If it's not supported, the wire breaks at the connector (I had to buy new wires and a PCB from Anycubic). You'll need to relocate the X switch using the provided X_Switch mount. This design uses the OEM metal backplate: no need to disassemble the X rod for installation - keep the linear bearings and complete backplate intact. The part cooling duct is a slight remix of the real deal AI3M Mega X carriage: I had to relocate the mount and location to fit on the OEM metal backplate, centering the nozzle with the hotend nozzle. The rear belt carriage is taken from the design by MT2. You'll need a few M3 screws in different lengths - I didn't document which goes where because I have a complete kit from Amazon with M3*6/8/10/12/16/18/20/25/40 screws.