Anycubic i3 Mega 10x10 Chain / Schlepp

thingiverse

Hello everybody! This is my version of a 10x10 chain mount. It's designed for the Anycubic i3 Mega with the Side Extruder Support mount v2 that I used from User Alpharic - Thank You! https://www.thingiverse.com/thing:2448418 I bought this chain from Amazon: NATE 10x10 Chain https://www.amazon.com/dp/B082B2NKT9/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1 Only two M4x10mm screws were needed. The threads are already available on the Z-Axis. You'll also need to remove the pins of the connector to put the cable in the chain, but it's not very difficult. Push down and lightly push backwards the pin like on the picture. Then pull on the cable. The pin should come out. To put it back, simply press it back into the connector. I tried to keep it simple. Have fun! --------------------------------------------------------- Hello everybody! This is my version of a 10x10 chain mount. It's for the Anycubic i3 Mega with the Side Extruder Support mount v2 that I used from User Alpharic - Thank You! https://www.thingiverse.com/thing:2448418 I bought this chain from Amazon: NATE 10x10 Chain https://www.amazon.com/dp/B082B2NKT9/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1 Only two M4 screws were needed. The threads are already available on the Z-Axis. You'll also need to remove the pins of the connector to put the cable in the chain, but it's not very difficult. Push down and lightly push backwards the pin like on the picture. Then pull on the cable. The pin should come out. To put it back, simply press it back into the connector. I tried to keep it simple. Have fun!