Anycubic Chiron Y-Motor Bracket

thingiverse

This is a brand-new bracket designed specifically for the Y Motor, replacing the old one due to its tight fit which caused vibrations to jump from the motor to the profile, resulting in unusual noises. To rectify this issue, the new bracket has been engineered with a slightly larger design, ensuring that the motor no longer makes contact with the profile. As a result, you will no longer need to use the small rubber buffer between the motor and the profile. This is version 1 of the updated bracket, and I anticipate making further improvements in the future. The bracket has been fabricated using PLA, but you can opt for any other material you prefer (PETG or ABS/ASA). To assemble this new bracket, you will need: * Two M5x30 screws to secure the bracket to the profile * A small amount of glue to fix the stiffener to the profile * One M4x10 screw and one Hammer nut M4 for additional support You can reuse the existing screws from the motor and end stop. Please note: It is crucial that you verify the following before commencing printing: Verify that the end stop sensor on the bracket is properly aligned with the bed.