ANYCUBIC CHIRON FULL GUIES (optional install precision piezo)

thingiverse

CHIRON FULL LINEAL GUIDE Update: The option to install a precision piezo sensor is now available. To do this, replace the rear reinforcement piece called REAR_REINFORCEMENT.obj with the two pieces named as piezo refuerzo carro piezo A and B. Update 2: A drawing for laser cutting of the 5mm aluminum bed support has been added to mount linear guides. This is thanks to @Rad088. Make this modification at your own risk! Please note that the X axis is limited to 370mm, which are the outer lines of the square drawn on the bed. The Z axis also loses a little bit, but I have not measured how much. Linear Guides in Y: Thanks to Nadeon's fantastic work: https://www.thingiverse.com/thing:3682048 Necessary Material: 1 unit of Guide MGN12C 500mm (with short carriage) for the X axis 2 units of Guide MGN12H 550mm (with long carriage) for the Z axes 1 unit of Radial fan 5015 1 unit of Mellow BMG metal extruder 1 unit of Fan (extruder) - currently using a 4020 2 meters of GT2 6MM strap (approximately 1.3m used) 1 unit of 20T pulley Screw Assortment M3-A2: http://s.click.aliexpress.com/e/WLDwXVQ Tnuts M3 (at least 12 units - not counting those needed for the Y axis) 2 units of M3x50mm screws (may be a little shorter, used for X axis tensioner) 1 unit of Countersunk screw M3x20 (pulley fixing) 4 units of M3X45 screws for extruder motor Nuts M3 (I have at least 12 units - recommend having some more on hand) Long hex nut M3x60 or 2 units of 30mm) (used for chain carrier support) M5 bolts and nuts are reused, along with existing limit switch stops. Please leave a screw to spare, it's always good to have an assortment on hand just in case. The end of X's journey is behind the car. To print: 2 x SEPARATOR Z 2 x ELEVATOR END STOP The rest 1 unit. I recommend changing the extrusion fan for a bigger one. Printed with PETG and at least 50% filler, gyroid filler.