Anycubic Chiron Direct Drive Part Cooling Fan Remix by RW

thingiverse

I was drawn to the original design's aesthetic but encountered problems with its fragility and print failure; none of the remixed versions or alternatives resonated with me, so I chose to build upon the original. The outcome was a double 8x3mm magnet mount that weighed 2g less than the original due to careful trimming. In addition, I incorporated a duct divider to significantly enhance air circulation within the design. The final version (v6) is showcased in the blue background. When printing, ensure you refer to the suggested settings; note that these were optimized for PETG material, and your settings may vary accordingly. The 8.15mm variant features enlarged magnet holes due to issues I faced with the 8mm version requiring minor adjustments. The magnets must fit snugly, so don't be surprised if some force is required to secure them in place; using calipers to precisely measure the width often resolves this issue, or the supplied flush-cuts can be used effectively. To avoid potential complications, consider printing with the 8.15mm version.