Anycubic Chiron 5015 Blower

thingiverse

This is a direct replacement mount for the 5015 style blower that integrates a mounting point for the fan board and hot end cooler in one unit. It enables you to keep the bed leveling sensor bracket securely attached. The installation process is quite straightforward, requiring only a few additional screws beyond what's included. ***Required Screws*** You'll need five 6mm M3 hex screws: * Three to secure the fan board * Two for attaching the base plate to the trolley Additionally, you'll require five 16mm M3 hex screws: * Four for mounting the hot end fan * One for securing the 5015 blower For optimal results, it's recommended that you install the fans first and then attach the unit to the trolley. Along the top side of the hotend fan mount, there is a slight overhang designed to conceal the fan wires. Be sure to route these wires before completing the fan installation. The temperature sensor and heat element wires should be routed up the back side of the cooler and over the top of the mounting bracket to the fan board holder. Once you've mounted everything, loosen the two mount screws and adjust the blower accordingly to prevent it from rubbing against the print.