Antique Door Stop Bumper Tip

thingiverse

I reside in a home that's well over a century old, and one of the bumpers from an ancient doorstop finally just disintegrated due to age. I could have ventured to a large box store and purchased a low-cost replacement doorstop, but what's the excitement in that? (Cue my wife rolling her eyes.) Printer Settings Printer Brand: MakerGear Printer: MakerGear M2 Rafts: No Supports: No Resolution: 0.15mm Infill: 100% Notes: I employed black Ninjaflex TPE filament at 235C, printing at 12 mm/sec. It has just the right amount of "give". Not too soft and not too hard. How I Designed This Fusion 360 I modeled this in Fusion 360 using only basic shapes. A lip was included on the end so it would snap into place like the original one did. No adhesives necessary. I'm including the Fusion 360 file in case someone would like to modify the bumper.