anti walk sfx100 actuator anchors

thingiverse

please read..... printed with pla, use whatever you like with PLA print infill with minimum of 50%. any less and you risk crushing the print when tightening the bolts to the static profile frame. these are not intended to to be tightened extremely tight, just enough where they will not shift. the free play will minimize any lateral forces to prevent them from shifting print walls minimum of 3mm, this will aid the washer from deforming the slotted edges when tightening. their are 4version; 4080 profile open and close hole version 4040 profile both closed hole version one side mount (mount bolts from the sides) one top mount the close version is needed if you dont have a sturdy frame and may be susceptible to flex, or need a bit more surface area. for the actuators shaft to move around. the open version does not have a bottom and the shaft will go through the anchor hole and rest on the frame. both version have slotted holes so that it can be adjusted to sit directly under the actuator shaft the rubber legs can be purchased at any hardware store. they are suppose to fit loosely on the shaft. the upper portion of the anchor also has some play. this is to allow the actuator some freeplay to move both within the leg holder and the anchor hole. this is to minimize stress on the anchors, and also prevent the actuators from shifting them. parts needed, 16 m8 x25mm bolts https://www.amazon.com/dp/B07ZF56PRG/ref=cm_sw_r_cp_awdb_imm_HDQQGSM70Y2EKRH0JSDC 16 m8 washers https://www.amazon.com/dp/B07L3SQBCB/ref=cm_sw_r_cp_awdb_imm_D3YX3RVZWD00QXMGC79B 16 m8 tnuts https://www.amazon.com/dp/B072FMDN2R/ref=cm_sw_r_cp_awdb_imm_FBSC4F3VPFB28FTP0KST 4 rubber legs size 1 and 1/4 inch SoftTouch Rubber Leg Tip (4 Piece), 1-1/4", White https://www.amazon.com/dp/B005CH4T3U/ref=cm_sw_r_cp_apan_glt_fabc_HZW7VNKKP1F5J0JWXYMY?_encoding=UTF8&psc=1 enjoy