Anti Pop for Microphone recording anti popper filter

thingiverse

I needed an anti-popper so I designed One. Just use an old pantyhose and some M3 screws. I think I used 5 M3 x 16mm and 2 M3 x 20. I recommend printing quite dense. The top part of the popper thingy that goes over the other one has very tight tolerance to hold the fabric in place, use a bit of force so that when it goes in it stays there for good. The diameter of the microphone brace thingy is 4.5 cm. If you need another one, modify it or ask me and I might redesign and make it parametric or something else. I added two alternative microphone clamps that you can make with a wire or a zip tie in case the clamp does not fit your equipment.