Antenna Wrench

prusaprinters

This is a handy little wrench for removing vehicle antennas before going through a car wash. I designed this for my 2015 Silverado, but it should work on any vehicle with a threaded antenna that uses a 10mm nut. That's 10mm flat to flat, not thread diameter... If you use a 10mm wrench to remove your antenna, this tool should work for you. I printed this with 100% infill and it only took about 1/2 hour. I recommend 100% infill for strength, but it will probably work fine for the most part with a minimum infill of 20%. The notch opening of the tool is intended for slipping on the antenna itself, then dropping it to the nut to be loosened. I did this for my wife who is vertically challenged and unable to reach a box end wrench over the tip of the antenna. Print Settings Printer Brand: Anycubic Printer: All-metal Mega Rafts: No Supports: No Resolution: .2 Infill: 100% Filament: Amazon Basic's PLA Orange Notes: Print as oriented in the STL without supports. Category: Automotive