Antenna mount for quadcopters

thingiverse

Mounts for your RX antennae are minimal. Insert a standard antenna tube into each mount and cut the tube in half or thirds as needed. This design is convenient because you can attach it anywhere that has an M3 screw. These mounts are connected by a thin strip, so they're essentially one file for both units. Simply trim off the strip when printing is complete. Print Settings: Printer: Fabrikator mini Rafts: No Supports: No Resolution: 0.1mm Infill: 100% Notes: Because these mounts are very small, use a brim to ensure they print correctly. After Printing: Inspect the mounts for any signs of damage or misalignment. If necessary, adjust the antenna tube to secure it in place. Your RX antennae should now be properly mounted and ready for use.