Antenna mount for 250 size quad

thingiverse

I crafted this mount specifically for my 250 size basher kwad. It simply slips over the rear stand-offs, allowing you to securely attach your VTX and RX antennas. The SMA connector of your VTX attaches via a sturdy hex nut, while the RX antenna mounts can hold PTFE tube with a 4mm outer diameter. These mounts are designed so that the antennas remain at a 90 degree angle to each other, no matter what orientation my kwad is in - this setup supposedly helps prevent failsafes. Print the part in its normal orientation, with the bottom of the legs on the bed, and use supports as needed. Filament temperature: 210 degrees Celsius Bed temperature: 60 degrees Celsius