Anschlagstop für Festool MFT/3 - Guide Rail Stop for use with Festool MFT/3

thingiverse

NOTICES: Non-commercial, free-of-charge provision of a single construction file in STL-format. This is a simple Guide Rail Stop for use with the support unit and swivel unit, respectively, of a Festool MFT/3 Rail Guide. The MFT/3 comes with 2 stops made out of steel, pre-installed in the front and back, used to easily position the support and swivel units each time at the exact same position. I needed two additional stops for the left and right side of the table, as I own a guide rail long enough to be used across the full length of the table, but did not want to remove the OEM stops. Note that the stops are absolutely NOT DESIGNED TO WITHSTAND ANY SIGNIFICANT FORCE, they are just indicators to easily locate again and again an individually preferred position for the support unit and swivel unit, both of which need to be securely clamped and tightened on their own. The length of the stop is similar to the OEM stops, making the stops easily visible. The guide is equipped with a threaded hole, designed to be used with an M6 grub screw with 10mm length and a flat tip. The .stl object as downloaded should be readily positioned in print position; note that the object is not fully symmetric but has a slightly inclined top surface (when looked at in final mounting position), so the object in print position is slightly cone-shaped. THE CONSTRUCTION FILE IS PROVIDED "AS IS". THE AUTHOR DOES NOT PURPORT AND DOES NOT REPRESENT, WHETHER EXPRESSED OR IMPLIED, THAT THE CONSTRUCTION FILE IS FREE OF ERRORS, FREE OF FAULTS AND USABLE FOR ANY PURPOSE: THE AUTHOR IS NOT AN EXPERT IN 3D CONSTRUCTION AND NO EXPERT IN ENGINEERING. THE AUTHOR DOES NOT ACCEPT ANY RESPONSIBILITY NOR LIABILITY OF ANY KIND FOR THE USE OF THE CONSTRUCTION FILE, REGARDLESS OF THE PURPOSE; THE LIABILITY FOR ANY DIRECT AND INDIRECT DAMAGE IS DECLINED. The use of trademarks, tradenames and other marks of third parties, if any, serves solely descriptive purposes pertaining to the construction file; the trademarks, tradenames and other marks of third parties are and remain the sole property of such third parties.