Anreisshilfe fuer Stahlmass 30cm/50cm (Streichmaß)

thingiverse

Anreisshilfe for Uniform Marking of Masses. The internal pressure plate prevents the wing screw from pressing against the steel mass and damaging it. Consists of: 1x Upper part 1x 30cm Steel mass / 50cm Steel mass attachment piece 1x Internal pressure plate (internal) 2x Guide pins (internal, not necessarily required) Additionally, the following is needed: 2x Screw M3x6 DIN 912 1x Wing screw M4x16 DIN 316. For example: https://www.ebay.de/itm/110907720207 Compatible with: Steel mass 30cm, 13.0mm wide, 0.5mm thick (measured) Steel mass 50cm, 20.1mm wide, 0.5mm thick (measured) Material: PLA Thickness: 0.2mm for upper part and attachment piece 0.1mm for guide pins and pressure plate Post-processing: 2 pieces of M3 thread cut, core hole in pressure present 1 piece of M4 thread cut, core hole in pressure present (somewhat tight) Ggf. The pressure plate and the pocket in the upper part may be slightly scratched. Limitation: Not suitable as a corner, since the steel mass has some desired play in the guide. Note: The guide pins are quite tight. Press them into the upper part without damaging the small pin on top. When assembling the upper part and attachment piece together, the small pin should press flat, making everything snugly fitted and not rattling. I have found that you do not necessarily need the two pins. Designed with: Freecad V018 2019-04-13 FrankWL