Another Modified Drag Chain Cable Raceway for OneFinity CNC

thingiverse

These are 2 alternate parts (X90deg and Xrear supports) and 1 new part (plug holder) for the [Drag Chain Raceway for Onefinity CNC](https://www.thingiverse.com/thing:4619804), created by Muddyfeet I really only wanted the Y axis raceway because I don't currently need the X axis raceway since my router power cord goes with my vacuum hose on the [Suckit Vacuum Hose Boom](https://www.thingiverse.com/thing:3235016) , and the existing coiled cable works fine. I still needed the X-90Degree support to attach the Y axis drag chain (and also be prepared to add the raceway if I decide to upgrade to a water cooled spindle). When I went to attach the X-90Degree support, I realized I had to remove the existing plug holder for the corded cable, which left me with no place for the plug. I used Fusion 360 to create a plug holder (just duplicated what came with the Onefinity) and was hoping to combine it with the [Modified Drag Chain Cable Raceway for X-50 OneFinity CNC](https://www.thingiverse.com/thing:4996178), created by JimAlex, but there was not enough room. So that led me to creating a new X-90Degree support with the plug holder built in. Since it was extended further than the other X-90Degree supports on Thingiverse, I created the X-Rear Support to match it, in case I decide to actually use the X axis raceway. Couple of other notes… I did not add the feet that go into the holes in the Onefinity for support. When I added the pieces on , they seemed very sturdy with just the bolts holding them. I figured I could always add them later if needed. Also, you don't need to print the plug holder. I created it as a duplicate of the existing one and chopped off the ends to add it to the X-90Degree support. Figured someone may lose theirs and need to reprint, so I included it.