Another Dice Tower Remix by Rolls17 tray add-on

thingiverse

This remix is a must-have add-on for anyone who printed "Another Dice Tower Remix by Rolls17" and found that the dice keep jumping out of the tray. I printed three of these dice towers before realizing the problem - so I decided to try my hand at 3D design instead of copying and pasting other models. A big thank you goes out to Rolls17, this is an incredible design! This add-on fits really tight. I print with brims, so the inner wall void needs to be cleaned up very well for it to fit perfectly. Do not use any supports - otherwise, this print will probably not fit. In order for this to fit, a bit of extra material had to be trimmed at the points where the ring meets the existing door frame and in the void underneath. The best way to attach this is to start at the door on both sides and work your way around away from the door until you hear a very satisfying "click". On my first attempt to install, I was sure it wouldn't fit but after approaching the alignment starting at the door, it popped right in. Tolerances may vary so extra trimming, resizing or gluing may be required for some. The printer brand used is actually SainSmart, not Creality.